• 分类：公司新闻
• 作者：
• 来源：
• 发布时间：2019-09-06
• 访问量：1

【概要描述】The rubber waterstop shall be set at the position with small stress and deformation, with an interval of 30-60m and a width of 700-1000mm. The rubber waterstop can be made into a straight joint, and the main reinforcement of the structure should not be disconnected at the joint. If it is necessary to disconnect, the lap length of the main reinforcement shall be greater than 45 times of the diameter of the main reinforcement, and the waterproof structure of the rubber waterstop with additional reinforcement shall be provided according to the scheme requirements. When the rubber waterstop needs to stop water in advance, the concrete at the rubber waterstop shall be partially thickened, and the externally bonded or buried waterstop shall be added. The advanced water stop should run through the whole process of the whole project until the end of backfill.